When is it right to use cutting fluid
(1) Before adding the cutting fluid, apply a special machine tool pipe cleaning agent to clean the cutting fluid pool and pipe dry, and carry out sterilization treatment.
(2) The concentration of cutting fluid can be higher for the first time, such as 4-10%. If it is used in the central central circulation cooling system, about 1% anti-mold agent can be added.
(3) Regularly supplement the cutting fluid, the concentration of the supplementary cutting fluid should be slightly lower than the initial addition (such as 2-5%).
(4) When preparing cutting fluid, deionized water should be selected. If tap water is used, the hardness of the water should usually be less than 400ppm. Otherwise, it is necessary to add special anti-hard water agent.
(5) To clean up the iron filings and filtration system in time to keep the cooling system clean.
(6) To often check the use of cutting fluid concentration, alkalinity and bacterial number to ensure that the cutting fluid is in good use.